Kenwood tm 721g инструкция пользователя

kenwood tm 721g инструкция пользователя
While it is fairly simple to install the SignaLink, it is possible to DAMAGE YOUR RADIO or the SignaLink by incorrectly installing it! Sample Page Lost User Manuals sells for $19.95 We would appreciate any comments: Artsci Inc. Mostly bad tantalums and mic problems. So easily fixed and easy to operate! You will need to use our SLCAB8R Mic cable and connect the SignaLink to the Mic jack instead. JP-1 Pin-outTigertronics manufactures a special cable for ICOM 13-pin Accessory Ports. Here is how.Disconnect po and antenna Remove top and bottom covers 2 screws) Remove the silver coloured screws from the front panel chassis.(2 on each side, 1 on p, 1 on bottom) Pulfront panel away from the dio but DO NOT disconnect cables.

What it DOES have though is the best receiver and audio for a mobile that has ever been made. I just don’t get it! The arrangement looks something like this: | | ____ ______ | I I:II (Bat-) |MPU | | (tery) | | | —- —— | | I The (:) above indicates where a jumper is to be placed. Unsolder an remove the coil (L6 or L9). Install and solder the new coil.

Specifications are guaranteed for the Amateur bands only.MODIFICATION PROCEDURE Disconnect the antenna, mic, and power cord. More info: Email SubscriptionYou are not subscribed to this review. This is the manuals page for Kenwood. In this page you find schematic, users and instructions manuals, service manuals, technical supplement, leaf leads and other good stuff. If you have some stuff that not is listed here you can donate this by contact Look at the centre of lithium battery a you will see R121 locatedown and to the left of the battery close to the bottom edge of the board about 3/4″ left of centre of the battery. Remove the top and bottom covers (11 screws). Do not damage the speaker wires when removing the top cover. This automatic- ally places the transceiver in the receive mode after 3 minutes of continuous transmit.

Похожие записи:

Опубликовано в рубрике Kenwood